In the preview window, enlarge the video and remove the logo watermark in the upper right corner of the video
Xiaominzi 2021-05-04 15:37:50

In the last article, I shared with you how to use custom actions to enlarge the video , Then make sure there is logo The part of the watermark goes beyond the video boundary to remove the watermark , But this method has a disadvantage that it will lose part of the video , Dragging and zooming in the video through the preview window described today will also lose part of the video , And the efficiency is not as high as using custom actions or shaking and zooming , This is just a general understanding , Just know how to do it .

Step one , Insert the video material into the overlay track , Then right click on the preview window , In the shortcut menu that pops up, click “ Adjust to screen size , Then right-click , single click ” keep aspect ratio “, As shown in the figure below ;


 In the preview window, zoom in and go to the top right corner of the video logo watermark

In the upper right corner of the video logo watermark

Step two , Move the video down in the preview window ; Put the mouse in the preview window, hold down the left mouse button and drag down to move the video material down ; As shown in the figure below ;


 In the preview window, zoom in and go to the top right corner of the video logo watermark

The preview window moves the material down

Why move the video material down a certain position first ? If you don't move the video material down, you can drag and enlarge it !

Step three , Put the mouse on the orange square in the upper right corner of the video material , The mouse becomes the shape of an arrow above and below , Then press and hold the left mouse button to move up and right , In this way, the width and height of the video can be enlarged in the same proportion , It won't deform the video material , If you put the mouse on the orange square in the middle of the four sides of the video material, and then drag , Only when the aspect of the amplification is wide or high , Will cause the video material to deform . Drag and zoom in as shown in the figure below ;


 In the preview window, zoom in and go to the top right corner of the video logo watermark

The preview window enlarges the video material

Step four , Drag and drop to enlarge the video material , Mobile video material , Make the top right corner logo The watermark is completely out of the preview window , At the same time, be careful not to put important content beyond the preview window . The effect picture after adjustment is as follows ;


 In the preview window, zoom in and go to the top right corner of the video logo watermark

Remove the watermark effect image by audio and video

Using this method to remove watermarks is more than using custom actions or shaking and scaling , And it's hard to control what goes beyond the preview window , The efficiency is also relatively low , This method is not recommended . In particular, it is not recommended to use the deformation tool to enlarge the video material , Because you can't control the aspect ratio of video material , It is likely to cause distortion of the enlarged video material , Affect the visual effect .

I'm Saburo , Please pay attention to me. , I will continue to update the knowledge of Huisheng Huiying , Let you learn Huisheng Huiying faster and more proficient than others ; If you want to learn the audio-visual knowledge systematically , Welcome to me ; If you have any questions, please leave a message below , I'll get back to you in time , Also welcome like-minded small partners to discuss and exchange .

版权声明
本文为[Xiaominzi]所创,转载请带上原文链接,感谢
https://fheadline.com/2021/05/20210504153445107m.html
相似文章